Reinforced concrete surface design for slabs, plates, and walls is possible in the RF-CONCRETE Surfaces module according to the ACI 318-19 or the CSA A23.3-19 standard. A common approach for slab design is the use of design strips for determining the average one-way internal forces over the width of the strip. This design strip method essentially takes a two-way slab element and applies a simpler one-way approach to determine the required reinforcement needed along the strip length.
在 RFEM 中,您可以使用导出功能将生成的 DXF 格式的有限元网格导出为 DXF 格式。 Hierfür kann der Exportdialog im Programm aufgerufen und das "ASCII-Format – Ergebnisse" gewählt werden. Neben einem Ergebnis, wie zum Beispiel der Isolinien, kann das FE-Netz im Register "Ergebnisse – Isolinien (.dxf)" angewählt werden. Nach dem Export ist das Netz im DXF im Layer DL-FE-MESH verfügbar.